In stock - ready to dispatch
This adjustable lifting beam handles heavy, uneven or offset loads by crane, with four lift points that slide along the beam to sit over the load's centre of gravity. It is rated up to 10,000 kg, depending on where the lift points are set.
Because the points move rather than the chains, there is less chain adjusting and fewer test lifts on awkward loads. The 4,995 mm beam weighs 500 kg. Where lift points are needed in two directions, choose one of our lifting frames instead.
You may also need:
View on this page or download.
Always read the manufacturer’s instructions before use. See the documents
Each of the four lift points runs along the beam and is fixed with a locking pin. Set them over the load's attachment points, mirrored on both ends of the beam, and the load hangs level even when its centre of gravity is off-centre.
The rating depends on two separate measurements. First, full 10,000 kg WLL needs the two top lifting points at least 1,620 mm apart.
Second, the distance from each lifting point to its drop chain should be no more than 1,440 mm; between 1,440 and 1,620 mm the WLL drops to 6,000 kg, and this distance must never exceed 1,620 mm. The beam must not be used as a single point lift, and its own 500 kg is added to the load on the crane hook.
A: When the two top lifting points are set at least 1,620 mm apart and each lifting point is within 1,440 mm of its drop chain. These are two different measurements. If a lifting point is 1,440 to 1,620 mm from its drop chain, the WLL is 6,000 kg.
A: Slide each point along the beam using its handle, line it up with the load's attachment point and lock it with its pin. Positions must be mirrored at both ends.
A: This beam has four movable points and up to 10,000 kg WLL for offset loads. The craneable beam has fixed points, 5,000 kg WLL and a choice of three lengths.
Loading your basket…
Delivery calculated at checkout.
CheckoutCard, Apple Pay, Pay by bank, proforma or 30-day account